emerio WC-126431 Mode D'emploi page 9

Turn the adjustable foot by hand (be careful of do not hurt your hands).
The appliance needs to be upgraded before loading of your wines, in a place where the soil can support the load.
Ambient temperature
The appliance should be placed in a room with temperature between 16-38˚C. If the ambient temperature is
above or below the climatic class, the performance of the appliance will be impacted. Cold or warm
temperature can cause fluctuating fridge temperatures, the appliance may not reach the set temperature or
may stop working.
FIRST USE
IMPORTANT: Wait for 24 hours before starting your appliance.
Meanwhile we recommend that leave your appliance upright, clean it and leave it open to eliminate residual
odors.
Recommendations:

Place the appliance in a cool place away from sunlight and heat sources.

Certain parameters such as room temperature, door opening time or the number of bottles stored inside
could affect the internal temperature of your appliance. We recommend that you check the internal
temperature regularly and adjust it if necessary.

Do not cover the vents.
Operating noise:
To reach the desired temperature, this appliance, like all wine fridges with compressor cooling systems, can
produce certain noises, which are normal operating noises.

Gurgling noise: caused by the refrigerant gas circulating in the refrigeration area of the unit.

Cracking noise: resulting from the contraction and expansion of the gas to produce the cold.
The perception of noise by the individual is directly related to the environment in which the appliance is located.
Noise in normal operation is not a cause of the warranty's application.
TEMPERATURE CONTROL
Please note that depending on the selected settings and the loading, it can take 24 hours for the appliance to
reach the desired temperature.
- Plug the power cord into a suitable power supply.
- Set the thermostat to adjust the temperature using the keys K2 and K3.
Light button
K1: Turns on / off the interior light
Increase button & Reduction button
Press the increase button K2, or reduction button K3 once, the LED display will flash indicating the current set
temperature. Press again to adjust the temperature. The new set temperature will blink 5 seconds and then be
saved. The LED display will indicate the actual temperature.
Temperature display
L1: The temperature can be adjusted from 5 to 20 degree according to the cycle below
Note: Symbol "%" in the lower right corner means humidity. It's not applicable to this product/model you
purchased.
Fahrenheit / Celsius mode
K4: Switch the temperature display between Fahrenheit / Celsius by pressing the key.
- 8 -