Machine Specifications; Technical Data; Noise Emission; Dust Emission - Jet JBS-12 Mode D'emploi

4. Machine specifications

4.1 Technical data

Wheel diameter
Cutting width
Cutting height
Sawblade length
Blade width
Blade thickness
Cutting speed
Machine Table(Lx W)
Table tilting range
Working height with stand
Dust port diameter
Overall without stand
(WxDxH)
Weight without stand
Overall with stand
(WxDxH)
Weight with stand
Mains
Motor power
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.2 Noise emission

Determined according to EN 1807
(Inspection tolerance 3 dB)
Workpiece beech:
T=30mm, L=1500mm, moisture 8,5%
Acoustic power level
(according to EN ISO 3746):
Idling
Operating
Acoustic pressure level
(EN ISO 11202):
Idling
Operating
The specified values are emission levels and are not necessarily
to be seen as safe operating levels. Although there is a
correlation between emission and imission levels, these do not
constitute a basis for determining the necessity of additional
safety measures. Workplace conditions which could influence
the noise imission level include the duration of resonance,
spatial particulars, other noise sources etc. For example, the
number of machines and other work being performed. The
permissible workplace levels can vary from country to country.
This information is intended to allow the user to make a better
estimation of the hazards and risks involved.

4.3 Dust emission

The band saw JBS-12 has been dust emission inspected.
At an air velocity of 20 m/s on the dust port dia 100mm:
Vacuum pressure
Volume flow
315 mm
max 305 mm
max 180 mm
2240 mm
6 - 15 mm
0,4 – 0,6 mm
370 or 800 m/min
400x480 mm
0° to 45°
1000mm
100mm
600 x 805 x1320mm
62 kg
655 x 915 x1860mm
68 kg
1~230V, 50Hz
800W
3,5 A
3x1,5mm²
10 A
LwA 85,0 dB(A)
LwA 96,4 dB(A)
LpA 72,6 dB(A)
LpA 83,4 dB(A)
1250 Pa
565 m³/h
The machine meets a workplace dust emission limit of 2 mg/m³.
4.4 Content of delivery
Open stand
Machine table
Fence
Fence support rails
Mitre gauge
Dust port 100mm
Assembly bag
Saw blade 13 mm
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and must
be placed stable on firm and levelled ground.
Stability of bandsaw.
Before using the bandsaw, ensure the machines upright
stability is satisfactory.
The bandsaw has four Ø 8mm holes (A, Fig 1) in it's base to
allow it to be bolted to a workbench or to the supplied open
stand
For packing reasons the machine is not completely assembled.

5.2 Assembly

If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Prior to use, the following items have to be fitted:
Bandsaw table, Rip fence guide and Crank handle.
5
Fig 1