Jet JBS-12 Mode D'emploi page 10

Blade drift can be caused by a number of factors.
- The saw blade follows the grain
- The saw blade is dull.
- Blade guides not adjusted correctly.
- Blade tension unsufficient.
- Blade-teeth have asymmetric"set"
With the blots (D and E, Fig 19), the rip fence profile can be
angled. This allows guiding the workpiece in line with cut.
Auxiliary fence for rip fence:
For your own safety always set the upper saw guide as close to
the workpiece as possible.
For narrow shallow cuts on the rip fence a self-made auxiliary
fence (E, Fig. 20) made of cutable material ( e.g. wood, plastic,
aluminium) must be used.
Length same as rip fence.
Fig 19
Fig 20
Mitre gauge:
Place the mitre gauge in the table T-slot.
Directions for "safe operation" :
Performing high resaw cuts
Performing diagonal cuts
10