Appendix; Batch Setup Function; Setup Using A Usb Flash Drive; Saving Settings To The Usb Flash Drive - Epson EB-585Wi Guide D'installation

Appendix

Batch Setup Function

Once the Configuration menu content has been set for one projector, you can use it to perform batch setup
for multiple projectors (batch setup function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.

• Setup using a USB flash drive.

• Setup by connecting the computer and projector with a USB cable.
• Setup using EasyMP Network Updater.
This guide explains the USB flash drive and the USB cable methods.
c
•
The following content is not reflected by the batch setup function.
• Network menu settings (except for the Mail menu and the Others menu)
• Lamp Hours and Status from the Info menu
•
Perform batch setup before adjusting the projected image. Adjustment values for the projected image,
such as Keystone, are reflected by the batch setup function. If batch setup is performed after adjusting
the projected image, the adjustments you made may change.
•
By using the batch setup function, the registered User's Logo is set for the other projectors. Do not
register confidential information and so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due to a power failure,
communication error, and so on, the customer is responsible for any repair costs incurred.
Setup Using a USB flash drive
This section explains how to perform batch setup using a USB flash drive.
c
•
Use a FAT format USB flash drive.
•
The batch setup function cannot be used by USB flash drives that incorporate security functions. Use
a USB flash drive that does not incorporate security functions.
•
The batch setup function cannot be used by USB card readers or USB hard disks.

Saving settings to the USB flash drive

a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
50