Setup By Connecting The Computer And Projector With A Usb Cable - Epson EB-585Wi Guide D'installation

Appendix
b
Connect the USB flash drive containing the saved batch setup file to the projector's USB-A
port
c
•
When the USB flash drive contains 1 to 3 types of batch setup files, the file is reflected to the
projector with the same model number. If there are multiple files for a projector with the same
model number, the settings may not be reflected correctly.
•
When there are four or more types of batch setup files on the USB flash drive, the settings may
not be reflected correctly.
•
Do not store any data except for the batch setup file on the USB flash drive. If the USB flash drive
contains data other than the batch setup file, the settings may not be reflected correctly.
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
When all of the projector's indicators turn on, release the [Menu] button. The indicators turn on for
approximately 75 seconds.
When all of the indicators start flashing, the settings are being written.
Caution
•
Do not disconnect the power cord from the projector while the settings are being written. If the power
cord is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the settings are being written. If the
USB flash drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off.
When the power turns off, remove the USB flash drive.

Setup by Connecting the Computer and Projector with a USB Cable

c
The following operating systems support the batch setup function.
•
Windows XP and later
•
Mac OS X 10.5.3 and later
52