Installing Welding Power Source Onto Rack - Miller Cst-8 Pack Rack Manuel Du Propriétaire

3-3. Installing Welding Power Source Onto Rack

OM-232 133 Page 10
1
4
Have only qualified persons make
this installation.
Y Turn Off welding power
sources before inspecting
or installing rack.
1 Welding Power Source
Position welding power source
onto rack shelf so that pins of front
mounting bracket are fully engaged
to front of welding power source.
2 Rear Mounting Bracket
Position rear mounting bracket so
its pins are fully engaged to rear
panel of welding power source.
3 Securing Bolts And Nuts
4 Rear Mounting Holes
Install supplied bolts through Rear
Mounting Bracket and Rear Mount-
ing Holes. Install bolts and tighten.
3
2
804 825-A