Babboe Big Instructions De Montage page 46

Step 4
CONNECTING THE FRONT AND REAR FRAME
You might need someone to assist you with this step. Position the front frame upright and
keep it horizontal. Slide the rear frame tube into the front frame. Check to ensure the tube
is fitting tightly. If there is some play between the front and rear frame, use one of the two
metal plates (included) to compensate for the play.
Use bolts kit H. Place the washer on the bolt. Then push the bolt through the frame.
Place the second washer on the bolt. Place the nut and hand-tighten it. Do not fully tighten
the nut just yet, this step will follow later. Use two 17mm ring spanners or wrenches.
46