Chapter 1: Setting Up; Connecting The Stereo - Sony HCD-T1 Mode D'emploi

Chapter 1:
Setting
up

Connecting the Stereo

Inserting the batteries
Setting the Clock
GB
4

Chapter 1: Setting up

Connecting the
Stereo
Use the illustrations below to connect your
stereo.
STEP 1 Connecting the
Flat Cord
(For only the customers using the TC-TX1
stereo cassette deck)
Connect the tuner CD player and the stereo
cassette deck with the flat cord (supplied)
pushing in the connector until it clicks.
To disconnect the flat cord
Pull out the connector of the flat cord while
pressing its sides. Do not pull the flat cord
itself.
STEP 2 Connecting the
Right Speaker
Connect the right speaker to the tuner CD
player with the audio cord (supplied) and
the mains lead.
Connecting the audio cord
Connect firmly the white plug to the white
(L) jack and the red plug to the red (R) jack.
White
Red
Connecting the mains lead of the
right speaker
Connect the mains lead of the right speaker
to AC OUTLET on the rear panel of the
tuner CD player.
Notes
The illustrations on page 5 shows the SA-N1
use active speaker system.
The rear view of the SA-N11 differs from the
illustration.
STEP 3 Connecting the
Left Speaker
Connect the left speaker to the right
speaker with the speaker cable (supplied).
Be sure to keep the speaker cable away
from the aerials.
Grey cord to ](red)
Twist each tip
Black-lined cord to } (black)
]
}