Step 1-: Connecting A 2Ch Sound Device - Sony DR-GA500 Mode D'emploi

Step 1-: Connecting a 2ch Sound Device
Connect the 2ch jacks of the processor by the supplied multi-channel cable. The EFFECT
function provides 7.1ch extended surround output from a 2ch input source.
1
Connect the processor to the
sound device as illustrated below.
Connecting jacks of the sound
device*
MIC IN
Connect to MIC IN jack
L/R OUT
Connect to L/R OUT jack
Not connected
Not connected
Not connected
* The jack name varies depending on the sound
device.
2
Slide the INPUT switch to "ch."
3
Set the ch speaker mode in the computer.
For details on operation of your computer/sound device, refer to the operating instructions
for it.
Do not connect the USB cable with multi-channel cable at the same time when you connect
the processor to the computer. The computer sound setting may be switched to an
unintended device.
10
US
Connection
Cable
plug
names
MIC

L / R

 SL / SR
C / SW

 SBL / SBR
Rear panel of processor
Front panel of
processor
Multi-channel cable
(supplied)