Troubleshooting; Common; Distorted Sound - Sony DR-BT101 Mode D'emploi

Troubleshooting

If you run into any problems using this unit, use the following checklist and read
the product support information on our website.
Should any problem persist, consult your nearest Sony dealer.

Common

The unit is not turned on.
 Charge the battery of the unit.
 The unit cannot be turned on while
charging. Remove the USB cable from
the unit, and then turn on the power.
Pairing cannot be done.
 Bring this unit and the Bluetooth device
closer together.
Cannot make the Bluetooth
connection.
 Check that this unit is turned on.
 Check that the Bluetooth connecting
device is turned on and the Bluetooth
function is on.
 Connection with the Bluetooth device
may not be memorized on this unit.
Make the Bluetooth connection from the
Bluetooth device to this unit soon after
pairing is complete.
 This unit or Bluetooth connecting device
is in sleep mode.
 The Bluetooth connection is terminated.
Make the Bluetooth connection again
(when listening to music: see page 14,
when calling: see page 17).

Distorted sound

 Ensure that this unit is not receiving
interference from a wireless LAN, other
2.4 GHz wireless device, or microwave
oven.
The correspondence distance
is short. (Sound skips.)
 If a device that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device(s),
or a microwave oven is nearby, move
away from such sources.
 Point the antenna of this unit (page 21)
towards the Bluetooth device. Make sure
no obstacles blocks the communication.
The unit does not operate
properly.
 Reset the unit. Pairing information is not
deleted by this operation.
Insert a small pin, etc., into the hole, and
push until you feel a click.
2
Continued
US