Panasonic CF-VDL02BM Instructions D'utilisation page 18

Troubleshooting
U n a b l e t o i n p u t b y
touching the display
The display is affected
E
The screen is shifted
horizontally or verti-
cally.
The display no longer
displays properly
18
Check the cable connection to the LCD Monitor.
Confirm that the [Serial Port] has not been set to [Dis-
able] in the Setup Utility.
Confirm that the setting for resource in [UPDD]*
tings] - [Hardware] and the setting of the Serial Port in the
Setup Utility are the same.
*
1
Windows Vista
Windows XP
Windows 2000
The mode not supported has been selected.
Set the display mode to 640 × 480 60 Hz, 800 × 600 60
Hz or 1024 × 768 60 Hz.
Check the cable connection to the LCD Monitor.
Select on the OSD main menu and perform fine
adjustments. ( page 15)
Select from the OSD main menu, then select [Init
NVRam], then press
Select [Yes], then press
Turn off the power to the LCD Monitor and then turn the
power back on again. (
: (Start) - [All Programs] -
[UPDD]
: [start] - [All Programs] - [UPDD]
: [Start] - [Programs] - [UPDD]
.
.
page 16)
- [Set-
1