Maintenance And Fault Elimination; Maintenance - Mettler Toledo EasyClean 100 Instructions D'utilisation

28

6 Maintenance and fault elimination

© 11/14 Mettler-Toledo AG, CH-8606 Greifensee
Printed in Switzerland
If you have any questions about faults or repairs, please contact your local METTLER TOLEDO
customer service. The addresses may be found at the end of this instruction manual.

6.1 Maintenance

The EasyClean100/150 is very service reduced.
To remove dust, dirt and stains, the external surfaces of the device can be wiped with a soft,
damp cloth. If necessary a mild detergent can also be used.
CAUTION
The housing may not be cleaned with any solvent containing acetone.
For further cleaning (e.g. blowing out the housing), you may use filtered compressed air that
is free of oil and water (pressure < 6 bar/87 psi).
CAUTION
The inside of the housing may not be cleaned using a liquid or a damp cloth.
The spray head is made of PVC or PVDF. You may use diluted acids or alkalis to remove dirt.
EasyClean100/150
EasyClean100/150
52 500 178