Responsibility, Organizational Measures - Mettler Toledo EasyClean 100 Instructions D'utilisation

12
Operator's
responsibilities
Personnel
responsibilities
Personnel selection and
qualification
– basic responsibilities
Constructional
modifications on the unit
© 11/14 Mettler-Toledo AG, CH-8606 Greifensee
Printed in Switzerland

2.6 Responsibility, organizational measures

– The operator must only permit personnel to work with the EasyClean if they are acquainted
with basic regulations concerning workplace safety and accident prevention, and familiar
with operating the unit. This instruction manual serves as a basis.
– In addition to the instruction manual, the operator must provide instruction in general statu-
tory and other binding regulations concerning workplace safety and accident prevention,
as well as environmental protection.
– Personnel safety and hazard awareness must be monitored regularly.
– Steps must be taken to ensure that the EasyClean is operated only while in a safe, properly
functional state.
– All persons working with the EasyClean must have read the section on safety and
responsibilities the warning notices contained in this instruction manual.
– In addition to the instruction manual, generally applicable statutory and other binding regu -
lations concerning workplace safety and accident protection must also be observed.
– Avoid any hazardous working practices that exceed the unit's intended purpose.
– Only dependable, trained or supervised personnel may work with the EasyClean. Operators
must read this instruction manual beforehand.
– Responsibilities for operating, maintaining, installing, etc. the unit must be clearly defined.
– Appropriate steps must be taken to ensure that the unit is used by authorized personnel only.
– Personnel under instruction, supervision or general training may only work with the unit
under constant supervision by an experienced person.
– Work on electrical parts of the unit may only be performed by a qualified electrician in
compliance with electrical engineering regulations.
– The unit may not be modified, extended or rebuilt in a way that impacts its safety without
written permission from Mettler-Toledo GmbH, Process Analytics.
– Any parts that are not in perfect working order must be replaced without delay.
EasyClean100/150
EasyClean100/150
52 500 178