Functions - Mettler Toledo EasyClean 100 Instructions D'utilisation

16
General
Types of operation
Basic setting
Hold function
Pilot lights
Program sequence
© 11/14 Mettler-Toledo AG, CH-8606 Greifensee
Printed in Switzerland

3.2 Functions

The EasyClean100/150 controls the supply of compressed air or water to an electrode tip,
which is integrated into an InDip housing (EasyClean100) or into a retractable housing
(EasyClean150). The flow is released and stopped via the transmitter's washing contact.
The transmitter assumes overall control of the device.
The valves are de-energized when closed.
In the event of a loss of pressure the InTrac housing remains in its last position. In the event of
a power failure in the EasyClean150, the sensor moves out of the process and the transmitter
changes to "hold mode" (reading is frozen).
In the event of a power failure, all functions of the EasyClean100 cut out, with no impact on
the reading.
For the exact function and settings of the Hold relay, please refer to the instruction manual for
the transmitter in question.
The EasyClean100 has no pilot lights.
The EasyClean150 has a pilot light (LED) built into the front. The light is connected to the
control valve that controls the housing movement. It does not therefore indicate any fault in
the operation of the housing, but only indicates the key status (automatic operation or in
retracted "service mode").
The rinse and wash time is indicated by the control signal (wash contact) of the transmitter,
(see transmitter's instruction manual).
EasyClean100/150
EasyClean100/150
52 500 178