ORGAPACK CR 25 A
5
INITIAL OPERATION
5.1 SUSPENDING THE TOOL
If the tool is equipped with a suspension bow (3/1) it
can be suspended on a spring balancer. By mounting
1
an M6-eye bolt (3/2) it is possible to perform horizon-
tal strapping.
5.2 COMPRESSED-AIR CONNECTION
Motor and sealing piston are lubricated by oil mist of
the compressed air. Properly prepared compressed
air is therefore essential for trouble-free operation of
the tool. This can only be ensured by a reliably func-
tioning maintenance unit, consisting of water separa-
tor, pressure reducing valve with pressure gauge and
oil mist lubricator.
The oil mist lubricator should supply suffi cient oil.
The length of the hose between the CR 25 A and the
maintenance unit should not exceed 5 m (15 ft). The
internal diameter of the pipe should be at least 10 mm
(
3
/
"). It must be ensured that the hose does not form
8
loops, where oil can collect.
2
Fig. 3
05.07/WE
21