Hoonved ELDING NORDIC TLC100 Mode D'emploi page 29

Part 3: Reserved for the technician
DISPLAYED ALARMS and WARNINGS: SELF-DIAGNOSTICS
If an ALARM or WARNING condition occurs, the relative code will be displayed.
Except for keys A1, A10, F1, F2 and F6, the START key turns RED until normal conditions are re-
stored or, in the event of a permanent alarm, until the machine is switched off.
ATTENTION
If
more than one alarm is triggered simultaneously,
the display will show the relative codes based on
this order of priority:
1. H1-H2-H3
2. A1-A2-A3-A4-A5-A6-A10
3. F1-F2-F3-F4-F5
The alarm and warning codes of the active functions
displayed during machine operation are:
A1
CYCLE NOT COMPLETED
This alarm is displayed when the wash cycle was
interrupted by switching the machine off with the
START key.
The alarm is reset when the next wash cycle starts.
QUICK
A2
ANOMALOUS OVERHEATING (BOILER)
This alarm is displayed when the temperature
in the boiler exceeds 105 °C or when at least
one of the temperature probes (tank/boiler) short-
circuits. The alarm is reset when the temperature
drops below 102°C or when the probe is replaced.
GLASSES
A3
DISCONNECTED TEMPERATURE PROBE
This alarm is displayed when one of the tempera-
ture probes (boiler and/or tank) is disconnected or
interrupted.
The alarm is reset when the probe is reconnected
properly.
GLASSES
A4
FILLING TIMEOUT (RCD versions)
This alarm is displayed when the tank does not fill
within 30 minutes or the RCD boiler does not fill
within 8 minutes.The alarm can be reset by turning
the machine off and on by pressing the START key.
FILLING TOUT
OFF
A5
BOILER HEATING TIMEOUT
This alarm is displayed when the boiler is not heated
within 30 minutes. The alarm can be reset by turning
the machine off and on by pressing the START key.
T ° S2 BOILER
OFF
A1
A2
A3
A4
A5
A6
WATER DRAINING TIMEOUT (partial dumper)
This alarm is displayed if the drain cycle does
not finish within 4 minutes.
The alarm can be reset by pressing the START key.
DRAIN TIMEOUT
OFF
A9
REGENERATION WARNING
This alarm is displayed
are reached. The alarm is reset after
the resin regeneration cycle is completed.
A10
TANK FULL WARNING
This alarm is displayed
the drain, sanitizing or regeneration phases start.
The alarm can be reset by turning the machine off
and on by pressing the START key
TANK FULL
OFF
H 1
INSUFF. RINSE WATER TEMPERATURE
This alarm is displayed if, during the wash
cycle, the rinse phase is carried out with the
boiler at least 15°C lower than the set temperature.
The washing cycle is prolonged until the
minimum rinsing temperature is reached
(max 8 minutes).
GLASSES
H2
NO WATER
This alarm is displayed when the rinse phase
is not carried out correctly.
Reset the alarm by turning the machine off and on
from the START key.
GLASSES
ENGLISH
A6
when the set cycles
A9
if the tank is not empty when
A10
H1
H2
29