Jenn-Air JXDR7301V Série Instructions D'installation Et Guide D'utilisation Et D'entretien page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Lift up the panel from the bottom mounting channel.
A. Blower mounting channel
B. Panel
6. Install the blower motor box assembly to the opposite side
(rear) of the vent box with the vent located in the bottom
venting position. Place the bottom tab of the blower box into
the bottom mounting channel.
A. Blower mounting channel
B. Panel
7. Plug in the wire connector to the blower motor.
A
B
A. Blower motor
B. Wire connector
14
B
A
B
A
8. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket. Slide bracket
into the "Z" slots and tighten the 2 hex/slotted head screws
to secure.
9. Reinstall panel to front side of vent box panel. Place bottom
tab of the panel into the bottom mounting channel.
A. Blower mounting channel
B. Panel
10. Tilt panel top tab so it is flush with the vent box panel and
position it under the tip mounting bracket. Slide bracket into
the "Z" slots and tighten the 2 hex/slotted head screws to
secure.
11. See "Complete Installation" section.
B
A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jxdr7361v sérieJxdr7301vs0Jxdr7301vs1Jxdr7361vs0Jxdr7361vs1

Table des Matières