Mounting - Panasonic Cz-Rtc6 Instructions D'installation

„ Using 1 indoor unit
Indoor unit
R1 R2
1 2
RC
(main)
Wiring as shown below is prohibited.
Indoor unit
R1 R2
RC
1 2
(main)
When setting both the main and sub remote controllers
After installation, set one remote controller to [Main] and the other to [Sub] for [Main/sub] for "Setting".
When using the remote controllers* in combination, set the CZ-RTC6 unit to [Sub].
*CZ-RTC5B
Note Remote controllers can be connected to any indoor unit for operation.

Mounting

1
Remove the top case.
1 Insert the screwdriver to the bottom case.
Insert the screwdriver to the claw as show in the figure.
A
Topcase
Bottom case
6
(EN)
All manuals and user guides at all-guides.com
„ Using more than 1 indoor unit
RC wiring
1 2
RC
(sub)
R1 R2
R1 R2
RC wiring
1 2
RC
1 2 1 2
(sub)
Flat-blade screwdriver
Claw (2 places)
Indoor unit Indoor unit
R1 R2 R1 R2
RC RC wiring
1 2
(main)
Indoor unit
R1 R2
R1 R2
1 2 1 2
RC
Push the screwdriver in.
2
Push down the screwdriver along with the slope of the
claw until the top case comes off.
View A
Topcase
Bottom case
Flat-blade screwdriver
Claw
Indoor unit
R1 R2
RC
1 2
(sub)
Indoor unit
R1 R2
RC wiring