Initial Use; Charging The Device; Attaching The Brush; Use - Beurer FC 65 Mode D'emploi

7.

Initial use

7.1 Charging the device

Charge the device for at least 6 hours before initial operation. To do this, proceed as follows:
1. Insert the mains cable into the charger.
2. Plug the mains adapter into the socket.
3. Insert the facial brush into the charger from above. Whilst charging, the blue LED light in the brush head flashes. As
soon as the facial brush is fully charged, the blue LED light is lit permanently.

7.2 Attaching the brush

The device features a soft brush attachment.
1. Fit the soft brush attachment onto the mounting fixture of the device from the front.
2. To remove the brush attachment after use, pull it forwards.
8.

Use

1. Moisten the attached brush attachment with water. Never use the device with a dry brush attachment as this can ir-
ritate the skin.
2. Apply the cleansing gel to your facial skin.
3. To switch on the device, press and hold the ON/OFF/speed button for one second. The brush attachment will begin
to vibrate.
4. The device features a slow, medium and fast speed setting. To switch between the individual speed settings, briefly
press the ON/OFF/speed button.
5. Using the function button, select your desired function. The device has a vibration function for gentle facial cleansing
and a pulsation function for thorough facial cleansing.
6. If you have problem skin, you can switch on a blue light during use which combats skin impurities and blemishes. To
add the blue light function, press the light button. If you have activated the pulsation function, the blue light pulsates
and is not permanently lit.
7. Now apply the device gently to your face and cleanse your facial skin using even movements to remove residue, dirt
and dead skin cells.
Note
To ensure comfortable treatment, do not press the brush attachment too firmly against the skin. Treat each section of skin
for a maximum of 20 seconds.
The brush features a 1-minute timer and stops every 20 seconds for 1 second to indicate that you should switch to cleans-
ing a different area. The facial brush switches itself off automatically after 3x 20 seconds. The recommended application
period per use is 1 minute.
8. Switch off the device after use. To switch off the device, press and hold the ON/OFF/speed button for one second.
9. Cleanse your face thoroughly with water to remove any residue from your skin.
10. Pat your skin dry with a towel and then apply a moisturising cream using even, circular movements.
9.

Cleaning

IMPORTANT
Before beginning cleaning, always pull the mains adapter out of the socket.

9.1 Cleaning the device and the charger

• Clean the device using only the methods specified.
• Clean the device after use with a soft, slightly damp cloth. If it is very dirty, you can also moisten the cloth with a mild
soapy solution. Do not use any abrasive cleaning products.
• Clean the charger with a soft, slightly damp cloth from time to time.
• Ensure that the device is fully dry before placing it into the charger.
11