Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
With the lamp status OFF, the lamp does not turn on
even if pulling the trigger.
NOTE:
To confirm the lamp status, pull the trigger. When
•
the lamp lights up by pulling the switch trigger, the
lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
While pulling the switch trigger, the lamp status
•
cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the lamp status can be changed.
Reversing switch action
CAUTION:
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
A
1
014641
Impact force grade
displayed on panel
Hard
Medium
Soft
014829
1. Reversing
switch lever
B
Maximum blows
Tightening when force
3,500
-1
and speed are desired.
(min
)
2,600
Tightening when you need
-1
(min
)
good controlled power.
Tightening when you need
1,800
fine adjustment with small
-1
(min
)
diameter bolt.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
Changing the impact force
2
3
4
1. Changed in three steps
2. Hard
3. Medium
4. Soft
5. Button
014644
Application
7
1
Work
Assembling the steel frame.
Assembling or disassembling
scaffolds or framework.
Assembling the furniture.
5
Publicité
Table des Matières
