To find out more about your product, consult the online EPREL database. As defined in
Commission Delegated Regulation (2019/2016 all information relating to this refrigeration
appliance is available on the EPREL Base (European Product Database for energy
labeling).
This database enables you to consult the information and technical documentation of your
refrigeration appliance. You can access the EPREL Database by scanning the QR code on
the energy label of your appliance or by going directly to www.ec.europa.eu and searching
the reference of your refrigeration appliance.
3. INSTALLATION INSTRUCTIONS
Location
When selecting a position for your fridge you should make sure the floor is flat and firm, and
the room is well ventilated. An average ambient temperature must be observed.
This temperature is specific according to the climatic class of the device:
• N: This refrigerating appliance is intended to be used at ambient temperatures ranging
from 16 °C to 32 °C
• ST: This refrigerating appliance is intended to be used at ambient temperatures ranging
from 16 °C to 38 °C
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight
in out-buildings or terraces/outside seating areas. If you are placing your appliance in an
out-building such as a garage or annex ensure that it is placed above the damp course,
otherwise condensation will occur on the cabinet.
Never place the appliance in a wall recessed or into fitted cabinets or furniture when it is
working, the metal grid at the back may become hot and the sides warm.
Never place the Fridge in a wall recessed or into fitted cabinets or furniture when your fridge
is working, the grille at the back may become hot and the sides warm. It must therefore be
installed so that the back of the fridge has at least 100mm of free space should be spared
at the top side, more than 100mm on both sides, and above 100mm at the back side of the
refrigerator.
Dimensions in mm
W
540
D
H
A
550
1760
910
B
C (°)
1055
130±5
27
E
F
50
100