Roborock Qrevo Pro Mode D'emploi page 10

Note: After spot cleaning, the robot will automatically
return to the starting point and be on standby.
Pause
When the robot is running, press any button
to pause it, press the button to resume
cleaning, and press the button to send it
back to the dock.
Note: Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND is on, the robot will not
automatically resume cleanup, the power
indicator light will dim, and the volume of
the voice message will lower.
Washing the Mop Cloths
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. During cleaning, tap Dock
button in the app to send robot back for
mop washing. When the robot is charging,
press and hold the button on the robot or
tap Wash button in the app to manually start
washing. Press any button to stop washing.
Notes:
• To allow the robot to wash the mop automatically,
start the robot from the dock and do not move the
dock during cleaning.
• Watch out for hot water and do not touch the water outlet.
• Mop wash frequency and washing mode can be modified
in the app.
Emptying
Auto-emptying will automatically begin when
the robot returns to the dock after cleaning.
To manually emptying, press
docked robot or tap the corresponding button
in the app. Press any button to stop emptying.
Notes:
• When auto-emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled through the app.
• Avoid frequent manual emptying.
Drying
Drying starts automatically after mop washing
or after cleaning is completed. To manually
start or stopping drying, tap the corresponding
button in the app.
10
Notes:
• Drying duration can be modified in the app.
• Auto-drying can be disabled through the app.
Charging
After cleaning, the robot will automatically
return to the dock to charge. In Pause mode,
press the
the dock. The power indicator light will breath
as the robot charges.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs, the power indicator light
on the robot will flash red or status indicator
light on the dock will be steady red. A pop-
up notification will receive in the app and a
button on the
voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system by pressing the Reset button.
Note: After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to factory
settings.
button to send the robot back to