Charging The Battery Pack; Insert Driving Battery Pack - Carson Fendt 930 VARIO TMS Mode D'emploi

a. Charging the Battery Pack
First plug the charger into the socket and then connect the
9.6 V driving battery pack to the charger's power supply cable.
Check that the charger is properly connected.
The battery pack supplied has a capacity of 750 mAh.
The charger has a charge current of 180 mAh.
This means that the 750 mAh 9.6 V battery pack is fully charged after
approx. 4½ hours.
If the optional 9.6 V battery pack with 1300 mAh is used, the charge
time increases to approx. 7½ hrs.
Warning!!!!
Do not exceed the charge time under any circumstances as
overcharging damages the battery pack.
b. Insert Driving Battery Pack
1. Open the battery cover.
2. Insert fully charged rechargeable batteries observing the correct
polarity.
3. Close the cover on the battery compartment again. Ensure that
the cover clicks properly into place. Check that it is in its correct
position.
2
CARSON 50 090 7171 (single tyre) / 50 090 7172 (twin tyre) Fendt 930 VARIO TMS
Connect firmly
1
3
GB
17