Reinstalling/Using Washer Again; About Detergent Concentration - Maytag W10254443B Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run washer through POWER WASH cycle to clean
washer and remove antifreeze, if used. Use only HE
detergent. Use half the manufacturer's recommended
amount for a medium-size load.
ABOUT DETERGENT
CONCENTRATION
Today's liquid HE detergents are concentrated. Most brands of
concentrated HE detergent will show the level of concentration
on the bottle. If so, simply set the concentration level in the
Optimal Dispense menu to match the level shown on the bottle.
However, if the detergent bottle does not give the concentration,
it can be easily calculated. Just divide the package size in fluid
ounces by the number of loads. Then refer to the chart below to
find the concentration.
If you do not get your desired cleaning results, try using a lower
concentration number. If you have excess suds, try using a higher
concentration number.
Concentration
Number of ounces ÷ number of loads
1x
2x
3x
4x
5x
6x
>2.5
1.5 - 2.49
0.9 - 1.49
0.7 - 0.89
0.5 - 0.69
0.3 - 0.49
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

W10254444b - sp

Table des Matières