Reinstalling/Using Washer Again; Troubleshooting - Maytag MVW18PDAXW Mode D'emploi

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.

TROUBLESHOOTING

Before calling for service on your washer, please try the solutions suggested in this section.
If you experience
Vibration or Shaking
Check the following for
proper installation or
see "Using Your
Washer" section.
Noises
Clicking or metallic noises
Gurgling or humming
Humming
Water Leaks
Check the following for
proper installation:
10
All manuals and user guides at all-guides.com
Possible Causes
Feet may not be in contact with the
floor and locked to cabinet.
Washer may not be level.
Load could be unbalanced or twisted.
Objects caught in washer drain system. Empty pockets before washing. Loose items such as coins could fall
Washer may be draining water.
Load sensing may be occurring.
Washer not level.
Fill hoses not attached tightly.
2. Plug in washer or reconnect power.
3. Run washer through Normal cycle to clean washer and remove
antifreeze, if used. Use half the manufacturer's recommended
amount of detergent for a medium-size load.
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in Installation Instructions.
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Wash smaller loads to reduce imbalance.
Do not tightly pack. Avoid washing single items.
Use Power Wash cycle for oversized, non-absorbent items such as
®
comforters or poly-filled jackets.
See "Cycle Guide" and "Using Your Washer" in this Use and
Care Guide.
between basket and tub or may block pump. It may be necessary to
call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the basket.
It is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during draining and spinning.
You may hear the hum of the sensing spins after you have started
the washer. This is normal.
Water may splash off basket if washer is not level. Check that load
is not unbalanced or tightly packed.
Tighten fill-hose connection.
Solution