Ryobi RY141612 Manuel D'utilisation page 56

USING THE FOAMER NOZZLE ATTACHMENT
See Figure 3.
WARNING:
Do not make adjustments while using the pressure
washer. Stop spraying and lock out the trigger before
making adjustments. Keep hands away from nozzle tip
when spraying.
n The amount of detergent in the spray is controlled by the
detergent flow lever.
• Push the lever all the way forward to use the detergent
at its highest concentration.
• Pull the lever all the way back to spray water only.
n Choose between two different water spray patterns:
When rotated to this symbol, the spray nozzle
provides a jet spray. Use this setting for apply-
ing detergent to items at a distance such as
second story siding.
When rotated to this symbol, the spray nozzle
provides a fan spray. Use this setting for apply-
ing detergent to items located nearby.
NOTE: When pointing the spray wand upward, water may
discharge from the sides of the spray wand nozzle. To stop
this discharge, point the spray wand downward for five
seconds and then resume normal operation.
When finished:
n Remove the detergent cup from the foamer nozzle and
rinse the cup with water to remove any detergent residue.
n Fill the cup with water, then reinstall.
n Spray the full cup of water through the foamer nozzle to
clean any detergent residue from inside the nozzle.
n Remove the foamer nozzle attachment from the spray
wand.
n Rinse the outside of the foamer nozzle attachment com-
pletely to remove any detergent residue. Allow all parts
to dry completely before storing.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
SPRAY NOZZLE
SPRAY PATTERNS
P.O. Box 1288
Anderson, SC 29622
1-800-860-4050
www.ryobitools.com
MORE WATER
FOAM ONLY
DETERGENT FLOW LEVER
Fig. 3
995000131
10-28-19 (REV:04)