Makita GS5000 Manuel D'instructions page 7

Securing method for tool with the
both types outer flanges
2
► 1. Screwdriver 2. Hex wrench 3. Inner flange 4. Hex
nut
Insert screwdriver into the hole in the inner flange. Grip
the hex nut with the wrench, turning in the direction
of wheel rotation to loosen the hex nut. Remove the
hex nut and outer flange. Then install the wheel, outer
flange and hex nut.
Tighten the hex nut in the direction of arrow as shown
in the figure.
OPERATION
CAUTION:
• Apply light pressure on the tool. Excessive
pressure on the tool will only cause a poor finish
and overloading of the motor.
• The grinding wheel continues to rotate after the
tool is switched off.
• Hold the tool firmly with one hand on the switch
handle and the other hand on the front grip
when performing the tool.
1
3
4
Hanger (optional accessory)
Continuous operation of the grinder is made easy by
using the handy hanger as shown in the figure. Simply
loop the cord over the head or shoulder, after threading
it through the eyelet on the top of the tool housing.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
► 1. Exhaust vent 2. Inhalation vent
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
7 ENGLISH
1
2