Sanding Disc Assembly And Disassembly - Hitachi S 18SA Mode D'emploi Et Instructions De Securite

English

SANDING DISC ASSEMBLY AND DISASSEMBLY

WARNING:
1. Assembling (Fig. 3)
(1) Turn the disc sander upsidedown so that
the spindle is facing upward.
(2) Attach washer nut, rubber pad and sanding
disc on the spindle, in that order.
(3) While pushing the lock lever with one hand,
lock the spindle by turning the rubber pad
slowly with the other hand.
Tighten the washer nut by using the
supplied wrench.
CAUTION:
Tighten the washer nut securely and
confirm that the rubber pad and sanding
disc does not wobble.
After releasing the lock lever, check to be
sure that it has returned to its normal
position.
2. Disassembling
To remove the sanding disc, follow the
above-mentioned procedure in reverse
order.
12
Never attempt to assemble or disassemble the sanding disc while the
disc sander is capable of being turned "ON".
Be sure power switch is in the "OFF" position and the electrical cord
has been disconnected from the receptacle.
Wrench
Spindle
Fig. 3
Tighten
Washer Nut
Sanding Disc
Rubber Pad
Lock Lever