Ryobi P5452 Manuel D'utilisation page 25

helps keep the chain away from abrasive surfaces,
such as the ground. Keep it on the right hand side
of the bar where it will be between the chain and the
ground during flush with ground cutting.
The mounting screw requires a 5/16 in. wrench (or
adjustable wrench) to achieve the recommended
torque of 35 to 45 in-lb. A torque within this range
can be achieved by using the following method.
 Tighten the screw with wrench until snug.
 From the snug position, tighten the screw an
additional 3/4 of a turn using a wrench.
TRANSPORTING AND STORING
See Figure 35.
WARNING:
Always remove the battery pack before trans-
porting or storing chain saw. Place battery pack
indoors in a dry, secure location out of the reach
of children when storing. Failure to follow these
instructions may lead to accidental starting or
unauthorized use and result in serious personal
injury.
 Do not store or transport the chain saw when
it is running. The chain saw should always be
idle before storing or transporting.
 Always place the guide bar scabbard on the
bar and chain before storing or transporting the
chain saw. Use caution to avoid the sharp teeth
of the chain.
 Clean the chain saw thoroughly before storing.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.
 Keep away from corrosive agents such as gar-
den chemicals and de-icing salts.
MAINTENANCE
TIGHTEN 3/4
OF A TURN
25 - English
MOUNTING
SCREW
SAFE-T-TIP™
Fig. 33
Fig. 34
Fig. 35