Fermax PLACAS SKYLINE LYNX Manuel D'installation page 32

L L L L L YNX Sk YNX Sk YNX Sk yline
YNX Sk YNX Sk yline yline yline Amplif
L L L L L YNX Sk YNX Sk YNX Sk
YNX Sk yline
YNX Sk
- In a PUSHBUTTON panel you can configure the pushbuttons
to call the different PMU (gurad units). The pushbuttons are
programmed using 5 digits. Depending on your configuration, a
pushbutton can call a group of PMUs as General Entrance, a
range of Various blocks or Block Entrance.
* General entrance:
100XX, where XX = PMU number [10000, 10099].
* Various blocks:
200XX, whereXX = PMU number [20000, 20099].
* Block entrance: YYYXX, where:
YYY = block number [000XX, 099XX]
XX = PMU number [00000, 09999].
- Call filter in PUSHBUTTON panels. You can activate a
restriction via a list of calls (up to 200 residence terminals), so
that you can only call the monitors/telephones that are included
in this list.
can always call a monitor/telephone even if not in the list of a
PMU.
This function is configured via the web server, via the Call
settings/Call filter box (activated).
Only monitors/telephones of the list (filtered) can see the panel
in its panels lists.
Pag 32
yline Amplif Amplif
Amplif Amplif ier
yline yline Amplif Amplif
yline Amplif Amplif ier
yline Amplif
ier ier
ier ier
ier ier
ier
ier