Fermax PLACAS SKYLINE LYNX Manuel D'installation page 31

L L L L L YNX Sk YNX Sk YNX Sk yline yline
YNX Sk YNX Sk yline yline yline Amplif
L L L L L YNX Sk YNX Sk YNX Sk
YNX Sk yline
YNX Sk
EN
Important notes:
- The PUSH BUTTON panel may only be configured remotely via
the incorporated web server.
- Various functions such as: Configuration of the push buttons,
audio and voice synthesiser language settings...etc, must also
be configured this way. This web server can be accessed via
the panel´s IP address. For more details see the LYNX Panel´s
Web server manual cod. 970020 at www.fermax.com.
- The panel's IP address can be configured by choosing between
different modes: Standard Lynx mode (default selection.
Button panels IP: 10.200.0.0.) / DHCP mode / Static IP mode.
- PUSH BUTTON panels are configured as a panel:
* BLOCK entrance: only calls the monitors in the same block.
The pushbuttons are programmed using 4 digits: [0001 - 8190].
* GENERAL ENTRANCE: calls the monitors of all blocks. The
pushbuttons
General entrance: BBUUUU, where:
BB = block number [00UUUU, 99UUUU]
UUUU = residence number [000001, 998190].
Amplif Amplif
Amplif Amplif ier
yline yline Amplif Amplif
yline Amplif Amplif ier
yline Amplif
are
ier ier
ier ier
ier ier
ier
ier
programmed using 6 digits.
Pag 31