Trouble Shooting; Elimination - Josef Kihlberg JK45-783 Mode D'emploi

Josef Kihlberg JK45-783
KUDA PACKAGING
8
Before all trouble shooting tasks on
the stapler it must first be
disconnected from the air supply.
FAULT
No staples when firing the tool.
Inadequate power. The staples do not penetrate
the material sufficiently.
Noise level is too high
Jammed staple in the nozzle
SERVIS A NAHRADNÍ DÍLY
10
www.kuda-packaging.com

TROUBLE SHOOTING

– Check that the right type of staples is being used
and moves easily inside the rail.
– Always use Josef Kihlberg original staples.
– Check for jammed staples.
– Check the feeder spring for defects. If
necessary replace.
– Check if the staple pusher is not defective. If
necessary replace.
– Clean the staple track.
– Air pressure too low. Secure that working pressure
is as recommend, see chapter 6.2
– Adjust the air pressure as chapter 6.2
– Has the tool been used without oil? Provide lubri-
cation, see chapter 5.2.
– Fit a longer driver blade.
– Check if the air pressure is correct. Adjust as per
chapter 6.2.
– Ensure that the work piece is firmly held in place.
Vibration causes high sound levels.
– Open the door and remove the defective staple,
see chapter 7.2.
+420 607 237 237
info@kuda-packaging.com

ELIMINATION

servis@josef-kihlberg.eu
06.14