Safety Instructions - Josef Kihlberg JK45-783 Mode D'emploi

Masquer les pouces Voir aussi pour JK45-783:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Josef Kihlberg JK45-783
KUDA PACKAGING
3
6 8 10
4
12
2
14
16
0
Original
KIHLBERG
SERVIS A NAHRADNÍ DÍLY
4
www.kuda-packaging.com

SAFETY INSTRUCTIONS

Inform yourself!
Read the operating
instructions carefully.
Protect yourself!
When operating the
stapler, wear eye, ear
.
protection
Warning: Danger of
crushing!
Do not put your fingers
underneath the nozzle.
Warning:
Hazard!
Lay the compressed air
hose so that there is no
risk of tripping over it.
Do not exceed the air
pressure!
Do not exceed the re-
commended air pressure.
Use safety coupling!
For connecting the air
hose to the stapler, use
only a safety coupling.
Do not use a bottled air
or gas source!
Do not operate this stap-
ler by using a bottled air
or gas source.
Never leave a loaded
tool unattended!
Always disconnect the
tool from air supply when
not in use.
Original
JOSEF KIHLBERG
staples must be used
exclusively!
Original
JOSEF KIHLBERG
spare parts must be
used exclusively!
Not using original spare
parts will dissolve the
warranty and the liability.
+420 607 237 237
info@kuda-packaging.com
Use for the intended purpose
The stapler is intended for stapling board to wood, and
wooden fram work.
This stapler was designed and manufactured for safe
handling during the stapling operation.
Possible misuse
Do not fire any staples into the air or use the stapler
with any other materials than mentioned above.
Servicing
The following maintenance work must be carried out
at regular intervals, varying with working conditions
and workload:
– daily check of compressed air pressure
5.5–6.5 bar (80–87 psi).
– clean the stapler regularly.
– check the condition of the stapler at regular inter-
vals for defects or worn parts. Never use a stapler
that has defective or worn parts (for servicing tasks
refer also to chapter 7.1 until 7.3).
servis@josef-kihlberg.eu
Warning:
Stapling and nailing tools
that are marked with
an inverted equilateral
triangle may only be used
in conjunction with an
operating safety support.
Warning:
Stapling and nailing tools
that are marked with this
symbol must not be used
when standing on a ste-
pladder or scaffolding.
06.14

Publicité

Table des Matières
loading

Table des Matières