Connecting The System - Pioneer AppRadio SPH-DA01 Manuel D'installation

Masquer les pouces Voir aussi pour AppRadio SPH-DA01:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connecting the system

Connecting the system
This product
(*1)
Control line cable
25 cm (9-7/8 in.)
25 cm (9-7/8 in.)
Wired remote input (SWC)
Please refer to the instruction manual for
the Hard-wired remote control adaptor
(sold separately).
(*1)
Make sure that the three yellow, green and blue connectors are attached before connecting the system.
WARNING
· To avoid the risk of accident and the potential violation of applicable laws, this product should never
be used while the vehicle is being driven except for navigation purposes. And, also rear displays
should not be in a location where it is a visible distraction to the driver.
· In some countries, the viewing of images on a display inside a vehicle even by persons other than the
driver may be illegal. Where such regulations apply they must be obeyed and this product's
App-based content should not be used.
8.5 cm (3-3/8 in.)
8.5 cm (3-3/8 in.)
Microphone jack
(MIC)
3 m (9 ft. 10 in.)
Output cable
25 cm (9-7/8 in.)
Antenna jack
Vehicle antenna
(RADIO ANT)
4 m (13 ft. 1 in.)
GPS antenna
iPhone or iPod touch (*2)
(*2)
For details concerning
operations and
compatibility, refer to
Important Information for
Users.
iPhone cable
2 m (6 ft. 7 in.)
Section
02
7
En

Publicité

Chapitres

Table des Matières
loading

Table des Matières