Velleman HQ POWER VDPC146 Manuel D'utilisation page 8

11) Running a Programme with TAP SYNC rhythm control
• Make sure the music control function is not active (press the AUDIO button to extinguish the AUDIO LED indicator
if necessary).
• Press the PARK button to select MIX CHASE. The yellow LED indicator is lit
• Select the programme you want to run
• Adjust the speed slider and press TAP SYNC twice to define the beat time
• Hold REC SPEED.
• Press the appropriate flash button under PRESET B to store the new settings
12) Running a Programme with the Speed Slider
• Make sure the music control function is not active (press the AUDIO to extinguish the AUDIO LED indicator if
necessary).
• Press the PARK button to select MIX CHASE. The yellow LED indicator is lit
• Select the programme you want to run
• Move the speed slider all the way down to SHOW MODE
• Hold REC SPEED.
• Press the appropriate flash button under PRESET B to store the new settings
The programme is now controlled through the real-time movement of the SPEED control.
13) Programming Example
• Put the device in the programming mode (see "2)
• Press MODE SELECT until the green LED indicator marked '1-24 SINGLE / PRESET PARK' is lit
• Slide both MASTER faders and the FADE slider to the highest position and the SPEED slider to the bottom.
• Select page 1 with the PAGE button
• Slide channel faders 1-3-5-7-9-11-13-15-17-19-21-23 to the top
• Press RECORD (the LED display shows 001)
• Slide channel faders 2-4-6-8-10-12-14-16-18-20-22-24 to the top
• Press RECORD (the LED display shows 002)
• Select CHASE / SCENES by pressing the MODE SELECT button
• Hold the RECORD button
• Press the first flash button in the lower channel faders portion (the flash button of channel 13)
• Release both buttons. All LED channel indicators flash momentarily.
The running light is now programmed on page 1 under scene 1.
Now we want to see the light in action :
1. Slide both master faders to the bottom
2. Slide the SPEED fader to the top
3. Slide SCENE 1 fader to the top
Move the SPEED fader up or down to adjust the speed of the running light. When the SPEED fader is all the way
down and is on SHOW MODE, then you can press the STEP button to view the scene step by step.
Press the AUDIO button (the green LED indicator will light) if you want the running light to react to music. Adjust the
music sensitivity with the AUDIOLEVEL fader. Press the AUDIO button again to leave the music control mode.
You can also synchronize the running light with the music manually : Tap the TAP SYNC button twice. The interval
between the two taps will determine the rhythm of the running light. In other words : tap the button twice to the beat
of the music. The SPEED fader will resume control when it is moved.
VDPC146
Record Enable (enter recording mode)" on page 5)
8 VELLEMAN