Connecting The Lcd Tv To A Pc; Using Side Av Connectors; Connecting To A Dvd Player Via Hdmi; Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable - Saba SVD2630 Mode D'emploi

• Multipartition HDDs are supported until two
partitions.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.

Connecting the LCD TV to a PC

For displaying your computer's screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LCD TV. When the connection
is made, switch to PC source. See "Input selection"
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts.
Audio inputs of the TV
PC audio cable
(not supplied)
Audio output of the PC

Using Side AV Connectors

You can connect a range of optional equipment to
your LCD TV..
• For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.
02_[GB]_MB60_(01-TV)_1900UK_PVR_ypbpr_26884W_BRONZE17_10072935_50189090.indd 55 02_[GB]_MB60_(01-TV)_1900UK_PVR_ypbpr_26884W_BRONZE17_10072935_50189090.indd 55
Connecting to a DVD Player via
HDMI
Please refer to your DVD player's instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note: Not all cables shown in the illustration are
supplied.
• If your DVD player has an
connect via HDMI for better video and audio quality.
• When you connect to DVD player as illustrated above,
switch to the connected HDMI source. See, Input
Selection section for more information on changing
sources.
Connecting to a DVD Player via
Component Sockets (YPbPr) or
PC input of the TV
Scart Cable
• Some DVD players are connected through
PC VGA cable
(not supplied)
COMPONENT SOCKETS (YPbPr). In this case,
you must use the supplied Component video
connection cable for enabling connection. First,
Monitor output of the PC
plug single jack of the cable to the TV's YPbPr
socket (side). Afterwards, insert your component
cable's (not supplied) connectors into the plural
part of the Component video connection cable (see
illustration below). Colours of the connected jacks
should match.
• To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match.
• When the connection is made, switch to
YPbPr source. See, Input selection section.
Note: To connect Y Pb Pr device, you should use
supplied component (YPbPr) connection cable
• You may also connect through the
English - 55 -
HDMI socket, you can
HDMI Cable
(not supplied)
External device
VGA/
SCART input.
01.06.2011 11:49:07 01.06.2011 11:49:07