Replacing The Belt; Accessories - Ryobi P611 Manuel D'utilisation

 Insert the blade holder into the cutter block assembly.
 Retighten the three blade securing screws using the blade
wrench.
 Repeat the above procedure to change the other blade.

REPLACING THE BELT

See Figures 17 - 18, page 13.
When replacing the belt, use the recommended replacement
belt only, RYOBI part number 039821001042.
 Remove the battery pack.
 Remove belt cover screws.
Look for these accessories where you purchased this product or call 1-800-525-2579.
Planer Blades ...................................................................................................................................................039821001057
Belt ...................................................................................................................................................................039821001042
NOTE: ILLUSTRATIONS START ON PAGE 11
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
 Remove the belt cover.
 Force the old belt from the small pulley by turning in the
direction shown. As you turn the belt, pull and work it
off the small pulley until it has been completely removed
from both pulleys.
 Install the new belt over the small pulley, being sure to
align the grooves. As you turn the belt, push and work it
onto the large pulley until it is in place.
 Replace the belt cover.
 Install belt cover screws and tighten securely.
NOTE: Do not overtighten the screws.

ACCESSORIES

10 - English