Kenwood CMOS-310 Mode D'emploi page 14

Display View Switching (CMOS-310 only)
Display View Switching
The CMOS-310 camera system can display 5 kinds of camera
images.
1
With an image displayed on the monitor, press
the view button of the switch unit.
Each press switches the image display mode in the following
order.
Super Wide View
Wide-angle image covering a horizontal angle of about 190°.
Wide View
Camera image covering a horizontal angle of about 135°.
Overhead View
Image seen from the viewpoint straight up above the vehicle.
14
|
CMOS-310/CMOS-210
PinP View
The overhead view is displayed on the upper half of the
screen while the wide view is displayed on the lower half. The
overhead view in the upper half of the screen shows the area
on the nearer side of the orange line shown in the wide view
in the lower half.
Corner View
The views seen from the two corners of vehicle are displayed
on the left and right halves of the screen.
When connecting the camera to a Kenwood navigation
system etc, (Control unit) equipped with the camera control
function, use the provided control unit connection cord. This
allows the control unit to switch the display view as well on
touch the control unit screen (page 7).