Kenwood CMOS-310 Mode D'emploi page 12

Camera Setting (CMOS-310 only)
Wide View Guideline Adjustment
(Vertical Direction)
This item adjusts the length of the guidelines displayed in
the wide view.
1
Select "WIDE VIEW GUIDELINE ADJUSTMENT
(Vertical direction)".
2
Press the + or – button of the switch unit to
adjust the length.
3
After completing the adjustment, press the
view button.
Advances to "WIDE VIEW GUIDELINE
ADJUSTMENT (Red Line Position Setting)."
12
|
CMOS-310/CMOS-210
Wide View Guideline Adjustment
(Red Line Position Setting)
This item adjusts the position of the red line displayed in
the wide view. The red line can be used independently to
set the reference line for the vehicle parking position.
1
Select "WIDE VIEW GUIDELINE ADJUSTMENT
(Red Line Position Setting)".
2
Press the + or – button of the switch unit to
adjust the position of the red line.
By default, the red line is superimposed with the yellow line
that is closest to the vehicle. Move the red line until the edge
of your vehicle's bumper.
3
After completing the adjustment, press the
view button.
4
Select [Next].
Advances to "SETTING COMPLETE".