Télécharger Imprimer la page

Cattini Oleopneumatica YAK 1815X Manuel Pour L'utilisation, L'installation Et L'entretien page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

FOREWORD
Dear Customer, before using your new jack, please read these instructions carefully and familiarise yourself with the safety
symbols.
- This manual is an integral part of the machine, and as such must be kept safe and to hand so the operator is able to
consult it whenever needed.
- The contents of this manual comply with the Machinery Directive 2006/42/EC, and the jack is type approved in conformity
with European Standard EN 1494, as amended.
- The manufacturer reserves the right to make modifications without prior notice, without prejudice to the safety and main
technical characteristics, and shall bear no liability in such an event.
- Failure to observe these instructions may result in personal injury or even death.
- The manufacturer shall not be liable for any damage or injuries caused by incorrect or improper use of the product. The
identification plate is placed on the jack.DWG. 1
SAFETY STANDARDS
- Use of the equipment shall be limited to authorised personnel, who must have fully read and understood the contents of
this operating and maintenance manual.
-The jack is purely a lifting device and must not be used as a support; it is therefore absolutely forbidden to perform
any kind of work underneath the vehicle being lifted until it has been placed on appropriate support stands.
- Before lifting a vehicle, this must be immobilised by applying the parking brake and/or by chocking the wheels, as
shown in the figure. DWG. 2
- If the vehicle is loaded, check the stability of the load when lifting.
- Place the jack so that the load is centred over it and at the grab points indicated by the vehicle manufacturer.
- During lifting and lowering, it is necessary to check there are no persons or animals under the suspended load or in the
vicinity.
- Never tamper with the pressure relief valve
- Do not leave any pressure in the pistons at end of stroke when there is no load.
PACKAGING
- The body and other parts of the jack are packed in a three-ply corrugated cardboard box with pallet; the operating and
maintenance manual plus the warranty certificate in a folder are also inside the box.
- The instruction "Keep upright" is clearly visible on the cardboard box containing the jack.
- Depending on the number of jacks shipped, pallets of different sizes are used.
- Either transpallets or forklift-trucks are used for handling.
4
EN

Publicité

loading