Candy CDSN 2D520PX/E Mode D'emploi page 106

Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "SMART DOOR/EXPRESS" and
"TABS" buttons will be on.
Pressing the "PROGRAMME SELECTION"

button until the "MEMO FUNCTION"
parameter is selected.
Parameter adjustment is performed by

pressing the "SMART DOOR/EXPRESS"
and "TABS" buttons to change the value
from "MEMO MODE ON" to "MEMO
MODE OFF" and vice versa.
Switch off the dishwasher by pressing the

"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Turn on the appliance using the
ON/OFF button.
2. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
3. "DEMO MODE ON" will appear on the
display.
4. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The PROGRAMME SELECTION/OPTIONS/
DELAY START options are enabled,
and by pressing these buttons you can
simulate the
without starting a wash.
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Turn on the appliance using the On/Off
button.
2. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
3. "DEMO MODE OFF" will appear on the
display.
4. Switch off the appliance.
CHILD LOCK
The dishwasher has an electronic child lock
feature. The child lock protects children
against the dangers that can result if the
dishwasher door is opened, and disables
the controls to make sure no undesired or
accidental changes are made.
Turn the child lock feature on and off as
follows:
Turn on the dishwasher by pressing the

"ON/OFF" button for about 3 sec.
Hold down the "SMART DOOR/EXPRESS"

and "TABS" buttons for about 5 seconds.
"CHILD LOCK" will appear on the display.

106
product's functioning