Candy CDSN 2D520PX/E Mode D'emploi page 101

15. PROGRAMME SELECTION
AND SPECIAL FEATURES
ON/OFF button
To turn the appliance on and off, press

the ON/OFF button (for at least 3 seconds).
At the end of the cycle, remember to
switch off the appliance using the
ON/OFF button, then remove the plug
and close the water supply.
First time you switch on the
appliance
Connect the machine to the power

supply.
Open the door, put the dishes to be

washed inside, and close the door again.
Press the "ON/OFF" button and hold for

about 3 seconds.
In this phase only the "SMART DOOR/

EXPRESS" "TABS" and "START/RESET"
buttons will remain active. The message
"BRAVA" will appear on the display and
all the indicator lights will turn on for 3 secs.
The message "ENGLISH" will appear on

the display.
Pressing the "SMART DOOR/EXPRESS"

or "TABS" buttons you can select the
preferred language.
 To accept the language selection press
the "START/RESET" button Immediately
afterwards the "WELCOME" message
will scroll on the display once and the
indicator lights will all be off.
"ECO" will appear on the display.

WARNING
In the event that the machine remains
switched on without selecting or
starting any program, after 5 mins. the
dishwasher will switch off automatically.
Next time you switch on the
appliance
Hold down the ON/OFF button for about 3
secs to turn the machine on and the "ECO"
programme or the programme you have
decided to use will appear on the display,
saving it when the dishwasher is switched
on. (To save the programme, see the
specific paragraph "Memorising the last
programme used").
Settings Menu
The dishwasher is regulated with certain
factory settings. Nevertheless, from the
Settings menu, you can adjust various
parameters to suit your washing requirements.
Entering the Settings menu
The dishwasher must ALWAYS be off
before you start this procedure.
Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "SMART DOOR/EXPRESS" and
"TABS" buttons will be on.
Pressing the "PROGRAMME SELECTION"

button you can select the parameters to
be adjusted in succession (SOFTENER
→ BUZZER → MEMO FUNCTION).
Parameter adjustment is performed by

pressing the "SMART DOOR/EXPRESS"
and "TABS" buttons.
To adjust the SOFTENER see the specific

Chapter of the manual.
To adjust the BUZZER see the specific

paragraph.
To adjust the MEMO FUNCTION see the

specific paragraph.
101