Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
2) If necessary (depending on countertop board material),
bend the sides of the mounting brackets.
If countertop board material is wood, etc.;
If countertop board material is ceramic, etc.;
18
ADJUSTING THE HEIGHT
1) Keep the front feet at the minimum height before and
while positioning the dishwasher into the cabinet cutout.
2) Adjust the front foot level with a slot screwdriver to
stabilize the dishwasher and raise it to the enclosure
height.
3) Adjust the rear foot level with a Phillips screwdriver to
balance and raise the dishwasher to the enclosure
height.
NOTE
Make sure the dishwasher is plumb and
note that the dishwasher can be placed
with
countertop.
For front feet; turning the feet in the
direction of the black arrows with the slot
Fig. 11
screwdriver
downwards.
For
screwdriver in the direction of the black
arrows will move the dishwasher feet
downwards.
Fig. 12
If the height of the enclosure is 34" - 36" (864mm-914mm),
use short supports as shown in the figure.
ops.(+50) H= 36" - 38" (914mm-964mm)
If the height of the enclosure is above 36" (914mm), use
long supports as shown in the figure.
a
small
clearance
moves
the
rear
feet;
turning
under
the
dishwasher
the
Phillips
Fig. 13
Publicité
