Description - Hilti PT 10 Mode D'emploi

Symbols
Read the Disposal of
operating power tools
instructions or
before use. appliances
and batteries
together with
household
waste is not
permissible.

2 Description

2.1 Use of the product as directed
The PT 10 is a quick check device that allows a single person to quickly and accurately check whether the accuracy
of a Hilti rotating laser, point laser or line laser is within the specified tolerance. The accuracy of the horizontal laser
beam is checked in each case.
NOTE
Important! Only Hilti laser tools featuring a visible laser beam can be tested.
2.2 Features
This device allows the user to test the laser tool quickly and easily (takes approx. 50 seconds). Operation of the device
is self-explanatory and the result obtained is clear and unequivocal. The PT 10 is compact and robustly built.
The accuracy of the following Hilti laser tools can be checked: line lasers, multi-line lasers, combilasers, rotating lasers
and pipe lasers.
2.3 Settings in accordance with the table of Hilti tools
Hilti laser tool
PML/ PMC/ PMM
PM 24/ PMP
PR 20/ PR 28/ PRE 3/ PRE 38/ PR 2-HS/ PR 300-HV2S
PR 25/ PR 26/ PR 35/ PR 3/ PR 30-HVS
PR 15
PR 16/ PRI 2/ PRI 36/ PR 3-HVSG
PP
The table of Hilti tools will be updated and replaced when new products are introduced.
2.4 Information displayed during operation
Small green LED
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
The green LED doesn't light.
The green LED doesn't light.
The green LED lights con-
stantly.
The green LED blinks.
Accuracy class Filter setting
9 I
9 II
1 I
2 I
5 I
3 I
1 II
The tool is switched off.
The tool is not connected to the electric
supply.
Beam search for the laser beam from
the tool under test is active. After
searching in beam search mode
unsuccessfully for 2 minutes, the
PT 10 quick check device reverts
automatically to standby mode.
Ready mode.
en
11