Citizen CT-S851 Mode D'emploi page 50

Switch no. Function
MSW10-5 Reserved
MSW10-6 Buzzer Sound
MSW10-7 Key Lock
MSW10-8 Reserved
Notes:
*1: If print data is very dense, the print head is hot, data transmission is slow, or some other
conditions, the motor and printing may occasionally stop which causes white stripes in the
printout. To print high-density data, set MSW2-3 (Spool Print) to ON to reduce striping, although
this increases the time before printing starts.
For a serial interface, increase the transmission speed to prevent the motor from stopping.
*2: The values for memory switches MSW7-X are only effective when DIP switch no. 1 is set to OFF .
*3: Enabled for firmware version Dxxx-2500 and later.
*4: Enabled for firmware version Dxxx-2300 and later.
*5: Enabled for firmware version Dxxx-2200 and later.
Initial setting
Tone 2 Tone 1, Tone 2, Tone 3, Tone 4
Invalid Invalid, Valid
— 46 —
Setting value