Publicité
Les langues disponibles
Les langues disponibles
Adjustable
Foot
Metal Plate
Adjust Feet
5. Position the Unit
IMPORTANT! Risk of product damage. Do not lift or support the overflowing bath by the pump or
piping.
NOTE: Do not use adhesive or a cement or mortar bed to secure this product to the subfloor.
With help, carefully lift the overflowing bath into place. Using metal plates under the adjustable feet
is recommended and will make leveling the bath easier.
NOTE: If you do not have a 6' (1.8 m) level, go to the next section.
Level by turning the adjustable feet up or down with the wrench (7/8") attached to the harness near
the pump. Make sure all six adjustable feet rest directly on the subfloor, and make sure the bathing
well rim is level within 1/8" (3 mm) in all directions.
Cut and discard the banding straps from the pump.
Make sure the rubber isolation feet are in place.
Insert the drain tailpiece into the trap.
Kohler Co.
Wrench
Check Level
9
Pump Banding
Straps
Cut Straps
1054216-2-B
Publicité
