Télécharger Imprimer la page

Benchmark HH0403 Mode D'emploi page 47

Publicité

Les langues disponibles

Les langues disponibles

8.5 SPARK PLUG SERVICE
NOTE
  DO NOT rinse spark plug in water. Follow guidelines and be careful not
to overtighten the spark plug.
Recommended spark plug:
  HH0403: F6TC
  BM1740: F6TC
  BLM2050E: F7TC
Check the spark plug gap and clean the carbon deposits at the bottom of the spark
plug.
Tighten 1/2 turn when installing a new spark plug.
Tighten 1/8 TO 1/4 turn when re-installing an old spark plug.
1.
Remove the spark plug cap.
2.
Remove the spark plug with the spark plug wrench.
3.
Visually inspect the spark plug. Replace with a new plug if the insulation is
cracked or chipped. Clean with a wire brush if the spark plug is reused.
4.
Measure the spark plug gap with a feeler gauge. The normal value is:
0.75 mm (0.029 in). Adjust the gap by carefully bending the electrode.
5.
Carefully reinstall the spark plug by hand, to avoid cross-threading. A new
spark plug should be tightened 1/2 turn with a spanner. A used spark plug
should be tightened 1/8 to 1/4 turn with spanner.
6.
Reinstall the spark plug cap.
Oil Dipstick
Spark Plug Cap
BM1740, BLM2050E, HH0403
43
0.75 mm
(0.029 in)

Publicité

loading