AEG FAVORIT 65020 VI Notice D'utilisation page 37

Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press RESET until the appliance is
in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the
appliance is in setting mode.
3. Set the programme.
• The related programme number
flashes in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration
that decreases with steps of 1 mi-
nute.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the display shows the de-
lay time you want to set (from 1 to
24 hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Close the appliance door. The
countdown starts.
• If you open the door, the display
shows the countdown of the de-
lay start that decreases with steps
of 1 hour.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the
appliance continues from the point of
interruption.
Cancelling the delay start while
the countdown operates
1. Open the appliance door.
2. Press the delay button again and
again until the display shows the
programme number.
3. Close the appliance door. The pro-
gramme starts.
Cancelling the programme
Press RESET until:
• The display shows two horizontal sta-
tus bars.
Make sure that there is deter-
gent in the detergent dispenser
before you start a new pro-
gramme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates.
1. Open the appliance door.
• The end indicator is on.
• The display shows 0.
2. Press the on/off button to deacti-
vate the appliance.
ENGLISH
37