Audio Control; Speaker Setting - Kenwood KDC-X579 Mode D'emploi

Rock
Pops
Easy
Top 40
Jazz
• User memory: The values set on the 'Audio Control'
(page 11).
• Each setting value is changed with the 'Speaker
Setting' (page 11).
First, select the speaker type with the Speaker setting.

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display
Bass Center Frequency*² "Bass F"
Bass level "Bass"
Bass Q Factor*² "Bass Q"
Bass Extend*² "Bass EXT"
Middle Center Frequency*² "MID F"
Middle level "Middle"
Middle Q Factor*² "Middle Q"
Treble Center Frequency*² "TRE F"
Treble level "Treble"
Balance "Balance"
Fader "Fader"
Sub woofer level*¹ "SW Level"
Front High Pass Filter*² "HPF F"
Rear High Pass Filter*² "HPF R"
Front/Rear High Pass Filter "HPF"
Sub woofer Low Pass "LPF SW"
Filter*¹
Volume offset "V-offset"
Loudness "LOUD"
"Rock"
"Pops"
"Easy"
"Top40"
"Jazz"
5

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Range
60/70/80/100 or 150 Hz
2
–8 — +8
1.00/1.25/1.50/2.00
3
ON/OFF
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 kHz
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–15 — +15
Through/100/125/
170 Hz
4
THRU/200 Hz
THRU/100/125/170 Hz
50/80/120/THRU Hz
–8 — ±0
ON/OFF
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• *¹ You can control this item when 'Switching preout'
(page 26) is set to "SWPRE Sub-W".
• *² Function of the KDC-X579
Exit Audio Control mode
Press the [AUD] button.
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
Enter Speaker Setting mode
Press the [Q] button.
Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4inch"
For 6 & 6x9 in. speaker "SP 6*9/6inch"
For the OEM speaker "SP O.E.M."
Exit Speaker Setting mode
Press the [Q] button.
11
|
English