Installation - Kenwood KDC-X579 Mode D'emploi

Installation

non-Japanese cars
Metal mounting strap
(commercially available)
Firewall or metal support
Self-tapping screw
(commercially available)
Screw (M4X8)
(commercially available)
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
Japanese cars
1
Refer to the section 'Removing the hard rubber
frame' (page 35) and then remove the hard
rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
T
N
8 mm
MAX.
3
ø5mm
Accessory3...for Nissan car
Accessory4 ...for Toyota car
• During installation, do not use any screws except for
those provided. The use of different screws might result
in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used
with excessive force during the installations.
N
T/N
T
T: Toyota cars
N: Nissan cars
8mm
MAX.
4
ø5mm
English
33
|